if you have any question? Call Us 0086-371-60922096
if you have any question? Call Us 0086-371-60922096
Gas-fired steam boilers are a very wide range of special equipments, widely used in food, chemical, paper, textile, construction and other industries. In the process of loading and installing a gas steam boiler, some problems must be paid attention, otherwise it may cause a certain degree of economic loss.
1. Pay attention to the following matters during the loading and unloading and handling of gas-fired boilers: the lifting capacity of the lifting equipment should match the weight of the lifting boiler. The lifting lug on the boiler with the lifting lugs that cannot be used for lifting can not be used for lifting. The length of the steel cord should be reasonably selected to avoid the scratching of the furnace due to the improper length of the steel cord. The boiler must be protected from any damage during handling and handling.
2. Reserves for maintenance space When installing boilers, ensure that there is sufficient maintenance space around the boiler.
3. Setting and precautions for the base and base of the gas steam boiler The boiler body must be installed on the basis of 100-150mm above the floor of the boiler room. It must be confirmed with the technical personnel of the boiler manufacturing company in advance and constructed according to the basic drawings. The anchor bolts must be reserved on the foundation. The foundation shall be capable of withstanding the maximum weight of the boiler and the amount of water it holds. When installing the base, you must first position it. After positioning, adjust to the same length of the two diagonals of the base, and then tighten all the fixing bolts. The installation of the base is carried out with reference to the reference line.
4, general precautions Be careful not to tilt and impact the boiler and accessories too much. No combustibles can be placed around the boiler. Do not use oil and water to smother the boiler. The boiler should normally be installed in a separate boiler room. The new gas-fired boiler room should not be connected to the house. The boiler room shall not be connected to Class A, Class B and Category C fire hazard rooms using flammable liquids. If connected to other production plants, the application firewall is separated.
5. The fire resistance grade and fire protection requirements of the boiler house building shall comply with the requirements of the Code for Fire Protection of Building Design and the Code for Fire Protection Design of High-rise Civil Buildings. The ground of the gas steam boiler room should be flat, non-flammable, no water accumulation, and the foundation load should meet the requirements. The power supply voltage of the gas steam boiler room should be stable to avoid causing the electrical components to burn out. If the voltage is unstable, it is recommended to install a voltage regulator. Ventilation equipment should be installed in the boiler room, and the boiler should be kept at room temperature below 50 °.
How to maintain the boiler shutdown? After boiler shutdown cooling, heating surface must be thoroughly cleaned of fouling and ash grate the upper, the lower portion of the furnace. Then to maintain a certain degree of natural ventilation flue. In general, in order desiccant moisture should be placed in the furnace, flue. The quicklime as a drying agent, within the furnace or flue gas per cubic meter should be placed generally about 3kg. After placing all the ventilation should be tightly closed doors. After the change of lime powder to be replaced. Low-lying position as boiler room, ground during shutdown severe flood tide, often approach should be used and placed a small fire to dry desiccant combination. How to care? If the boiler shutdown a long time, the boiler shutdown after complete removal of soot coated with an anti-corrosion red lead paint in oil or other metal surface furnace. As internal corrosion Maintenance shutdown of the boiler body, under normal circumstances, can be used wet shutdown maintenance is not more than one month, one month electrically operated szs series fired steam boiler should be taken to dry more maintenance. To note the following problems when a dry maintenance: desiccant boiler not in direct contact with the metal surface, may be mounted in a container such as the iron plate after the desiccant is placed, and a hole for shutting the other hand hole cover.
Gas-fired szs series fired steam boiler safety valve from installation to use, it must remain vigilant safety valve is one of the most important components of the gas steam boilers, boiler probability of the risk occurring due to various incidents can effectively suppressed. This article focuses on the safety valve from installation to use several important considerations, we do not ignore the use of gas when it steam boiler. A Notes 1 safety valve, the safety valve should be mounted vertically in a high position in the pot business, set box. 2, between the safety valve and the drum or header, not equipped with access to the steam outlet pipe and the valve. 3, the lever-type safety valve should prevent movement of the self-apparatus and the weight limit leverage deviant guide tube, a spring safety valve should lift and handle means for preventing movement of the adjustment screw is screwed lightly. 4, the rated steam pressure less than or equal to 3.82MPa gas steam boiler safety valve throat diameter of not less than 25mm; power greater than the rated steam pressure 3.82MPa boiler safety valve throat diameter not less than 20mm. 5, the safety valve and coal-fired steam boiler tubes, the cross-sectional area not less than the cross-sectional area of the valve inlet. If several valves installed together with a short tube directly connected to the drum, the cross-sectional area of the passage should not step short tube to 1.25 times the area of all the exhaust valve. 6, the safety valve should normally be installed exhaust pipe, exhaust pipe should be through a safe place, and there is sufficient cross-sectional area to ensure the smooth flow of exhaust. 7, the safety valve exhaust pipe at the bottom should have received a place of safety posturing of drainage pipe, the exhaust pipe and drainage pipe not allow the installation of the valve. 8, rated evaporation to 0.5t h coal-fired steam boiler /, at least two safety valves installed; Rated evaporation 0.5t h less than or equal to electric boiler /, mounted on at least a safety valve. 9, separable economizer outlet, the steam superheater outlet valve must be installed.
Shanxi Province is located in China's western areas north of the Loess Plateau, the terrain finished solid, rich products. Thanks to energy supply and price advantage of coal, coke, metallurgy, electric power and other coal industry, the rapid rise of the formation of Shanxi coal-based economies of resource-based industries.
Shanxi Province, but had coal and Xing, but also because of the coal and sleepy. According to the report, "2017, Shanxi Province, coal accounted for the proportion of energy consumption up to 84.6%, higher than the national average of 24 percent, it is 2.9 times as much as the global average of Shanxi to 1.6% of the national land area, consuming about 10% of national coal amount. for Shanxi, winning the battle of blue sky, coal pollution can be effectively controlled is the key.
According to the "Blue Sky Battle Shanxi three-year action plan," issued in July this year (hereinafter referred to as "" Shanxi three-year action plan '') planning requirements, by 2020, sulfur dioxide, total nitrogen oxide emissions are lower than in 2015 more than 20%, compared to strive average concentration of sulfur dioxide in 2015 fell about 50%. Among them, 2020, total coal consumption in 8 cities in key areas to achieve negative growth, the province's coal consumption in primary energy consumption share dropped to 80%, the proportion of the province's coal consumption of coal accounts for more than 55%.
According to Shanxi Province Bureau of Statistics latest data, as of the end of August this year, Shanxi Province, the outgoing power 50.67 billion kwh, up 21.1%; the first half of Shanxi new energy consumptive power grid to complete 15.6 billion kilowatts, an increase of 58.2%, new energy abandoned consumption fell 90.6% year on year, abandoned electricity rate fell 10.2 percentage points.
The past two years the province shut down 52 coal mines, quit production capacity 45.9 million tons, subtract coal production capacity of 9.25 million tons per year, the completion of energy-saving 18 million kilowatts of coal-fired power plants, coal-fired power plants province's average coal consumption of electricity of 320 grams per kilowatt-hour of standard coal. In the first half of this year, the province's above-scale industrial Shanxi coal industrial added value increased only 0.8%.
SZS series gas oil boiler steam boiler Introduction. SZS series gas oil boiler is designed with longitudinal double drums and " D " type chamber structure. Furnace is placed on the right and convection tube bank is on the left, super heater is arranged at convection tube bank.Get a Quote
2020-1-17·SZS series boiler is designed with longitudinal double drums and " D " type chamber structure. Furnace is placed on the right and convection tube bank is on the left, super heater is arranged at convection tube bank. The body is fixed on the basement by middle and both end flexible supports and make the boiler expand horizontally sideways.Get a Quote
SZS series automatic gas (oil) fired steam/hot water boiler adopts vertical double-drum D-shape structure, Longitudinal drum,full membrance wall structrue, slightly positive pressure combustion.Get a Quote
75 ton gas fired steam boiler usos.in. Gas Steam Boiler Gas Fired Boiler Gas Boiler Gas . 2019-7-1 · SZS series gas steam boiler is designed and optimized to produce low pressure steam or hot water with rated evaporation capacity from 4 to 75 ton/hour and rated pressure from 0.7 to 2.5MPa.Get a Quote
Features of SZS horizontal gas fired Steam Boilers Steam Boilers Boiler body uses the forced circulation in the high temperature area to make sure all heating areas can be cooled down and avoid vaporization; The explosion door and flame detector are equipped for safe and reliable operation.Get a Quote
2020-1-19·SZS series gas-fired (oil-fired) steam boiler. DZL series coal-fired steam boiler. Leave a message. Product. Capacity. Message. Our company's main products include gasamp;oil-fired boiler, coal-fired boiler, biomass boiler, thermal fluid heater and other series with more than 400 varieties ofGet a Quote
15tph SZS series gas-fired saturated steam boiler project for building material industry. In the building material industry, the aerated concrete block is a new type of lightweight building material. 1T/H Gas Steam Boiler to United Kingdom. The Customer purchase the 1 t/h gas steam boiler for Hotel Laundry Room. At present, the boiler has beenGet a Quote
Our SZS series gas steam boiler has the characteristics of compact structure, high burning efficiency, longitudinal drum, full membrane wall structure and slightly positive pressure combustion. SZS series gas-fired (oil-fired) steam boiler Gas-fired . SZS series boiler is designed with longitudinal double drums and D type chamberGet a Quote
customized the system solution of SZS series gas-fired steam boiler for Samsung Electronics. Combined with an advanced low NOx burner, the large furnace of the boiler can ensure the fullGet a Quote
2020-3-9·SZS Series Boiler is double drums, longitudinal arranged, "D" type chamber structure. Furnace is on right side and convection tube bundle is on the left, super heater is arranged at convection tube bundle. The body is fixed on the basement by middle and both end flexible supports and make the boiler to expand horizontally to sideways.Get a Quote
2020-4-27·SZS Gas Fired Boiler. SZS Oil Fired Boiler Product Description SZS series gas steam boiler is with D-type arrangement, natural recycling, double-drum water tube boiler. Longitudinal drum, full membrane wall structure, slightly positive pressure combustion. Furnace is wrapped by membrane wall, smoke enters the convection bank which is betweenGet a Quote
2020-1-17·SZS Gas-fired steam boiler Introduction SZS Series Boiler is double drums, longitudinal arranged, "D" type chamber structure. Furnace is on right side and convection tube bundle is on the left, super heater is arranged at convection tube bundle.Get a Quote
high quality industrial oil fired boiler suppliers, Our gas fired oil fired boilers can be divided into SZS water tube boilers and WNS fire tube boilers depending on the medium inside the tubes. With multiple pressure designs, the water tube boilers can meet the steam supply requirements of 2.5MPa or above.Get a Quote
SZS series gas-fired (oil-fired) steam boiler. By xuyi01 Published December 6, 2019 Products. Product thermal capacity: 10-100 t/h. Working pressure: 2.5-9.8 Mpa. Outlet temperature: 194-540 °C. Available fuel: Nature gas, coke oven gas, blast furnace gas, carbon black off-gas, biogas, methanol, LPG, diesel, heavy oil, light oil, crude oil, etc.Get a Quote
SZS series low NOx gas-fired saturated steam boiler for fruit juice industry; 10 tph WNS series gas-fired fire tube boiler for hospitals; 25 tph SZL series chain grate steam boiler for Balasu coal mine project ; DHL series corner tube hot water boiler project for heating industry; 20 tph SZL series biomass fired boiler project for rubber industryGet a Quote