As fast low pressure boilers seller manufacturer specialized in the production of gas boilers and electric boilers, it has gone through 20 years of development history. The energy-producing gas boiler and then fully welded to the pre-expansion, and finally Expansion technology, both to prevent corrosion of the tube gap, but also enhance the welding strength; threaded pipe using a high heat transfer coefficient, heat strengthening effect on the spread , reduce exhaust gas temperature and improve the thermal efficiency of the boiler. With industry-leading gas boiler products and perfect after-sales service, fast boiler boiler by many users of gas acceptance and trust.

If natural gas as low pressure boilers seller fuel choice, because the convenience of clean natural gas and fuel used in the boiler service life will be over 10 years; but if it is a boiler coal or other fuels, it will shorten the life of some. Further, the life of the boiler with the use of the frequency, the higher the frequency the shorter the life of the boiler, the greater the contrary. Late boiler maintenance is also very important for the life of the boiler, good maintenance will extend the life of the boiler.

Primary air tube blockage is what causes? How to prevent? Reason: 1) blocked or coked-burner fire nozzle inlet is blocked portion of small oil gun and other debris. 2) too many impurities coal, powder machine speed is too high, the pulverized coal and primary air speed too low. 3) powder machine speed is too high, too much under the powder without timely blown away. 4) a low pressure (throttle open or not to open too small), can not take away meal. Precautions: 1) to the powder and the rotational speed of the unit load and adjust relevant primary pressure according to the powder not more than 700 rpm rotation speed, a wind speed of each holding 25 ~ 30m / s, the mixed primary air temperature was controlled at 180 to 250 ℃, a pressure depending on the load, depending on coal, in the range 2.5 ~ 3.8kPa. 2) find a wind speed is too low, the primary air temperature is lower than the normal value should be to lower the rotation speed corresponding to the normal to the powder of a primary air temperature and wind speed. 3) open, gas steam low pressure boilers seller tank should be fully cut-off torch powder, the powder in the tube is blown accumulated powder. 4) Fire mouth clogged or coked should try to remove. What causes large vibrations induced draft fan? 1) motor bearings in oil, resulting in large vibration and bearing wear; 2) even when the shaft is mounted on the center not good; 3) induced draft fan stall surge; 4) anchor bolt loosening induced draft fan; 5) blade fouling or wear ,lost balance.

This is our first collaboration with fast low pressure boilers seller, professional and caring service fast boiler's impressed us. From pre-sales advice to after-sales guidance, every step is very careful and thoughtful. They provide hot water boiler performance is also very good, and effectively improve the level of our heating units. --customer feedback